Handle bumper/snubber, direct OEM part replacement.

This part is made of superior materials that withstand the rigors of long term use. Chemical resistant TPU rubber mounted on a glass fiber reinforced ABS frame. This makes for an ideal replacement part to restore a pull handle to proper functionality. We have started using these in all cases where a handle rebuild is indicated. 

Installation involves: 1 removal of handle from machine. 2. Remove solenoid from handle. 3. Remove 3 Phillips head screws from handle. 4. Remove handle springs then Loosen the three 7/16" nuts holding the handle halves together, no need to fully remove these fasteners. 5. Remove old snubber with needle-nose pliers and slip the replacement in. 6. Check alignment of parts and re-tighten the handle halve fasteners. 7 Reinstall the Phillips screws and solenoid. 8. Reinstall handle in machine.